Xhorse Dolphin XP007 Cannot Slide Workstation Solution
Problem: I had a problem with my Xhorse dolphin xp007 manual key cutting machine. Can’t slide back and forth, can only spin in circles. Any solution?
The workstation (Y direction) cannot slide or shake back and forth solution:
Step 1: Turn the device over. Check if there is something stuck in the sliding gap of the bottom rail.
If yes, clear dirty stuff
If no, do Step 2.
Step 2: Adjust the 2 Kimi screws on the right side against the guide rail, and move the cross slide back and forth. If the cross slide is smooth and not stuck, tighten the 8 screws immediately
NOTE:
Tip: If the 8 screws are loosened, do not tighten the 8 screws immediately. The 2 Kimi screws on the right side need to be adjusted to ensure that the cross slide moves smoothly before tightening the 8 screws.
