Situation 1:

The ‘function not activated’ error occurs when you have not got the xhorse vvdi key tool max ID48 96bit cloning license activated.

Take 10 brand new xhorse remotes and just generate any remote to them. Once you do that it will be activated, it has to be 10 new never used remotes, just generate each 1 1 time, you can generate them over again later when you use them.

Check detail instruction here: How to activate id48 96bit cloning on keytool max?

Situation 2:

I still have this error after generating 10 remotes and got the id48 96bit copy license activated, I don’t see the option under shop>function.

Change network connection and sync device.

Update xhorse key tool max software or firmware and try again.

 Fiat stilo 2004 all keys lost is done by xhorse vvdi key tool plus via dump.

 The TOY40 emergency key is very thin, only 1.5mm with one side. So if using 2.5mm cutter, Xhorse Dolphin XP005L will give a 33 error code. Following I’m gonna show how to decode & cut it.

For Dolphin XP005 or Condor XC-Mini Plus key cutting machine, you’ll need to use M2 clamp & bar adapter. New Dolphin II M5 clamp can cut without bar adapter.

Decode Key

Vehicle database >> Asia >> Toyota >> TOY40 emergency key(one side key)

Install the original key on M5 clamp side B, tip align 2^nd position.

Press “Decode key”.

The Dolphin II will start decoding, just wait until completed.

Its bitting codes have been read out.

Cut Key with 1.5mm Cutter

Install new key blank on M5 clamp, press “Cut key”.

It mentions “Error code:33, cutter diameter tool large.” while the warning red light is flashing. That means the TOY40 one side key cannot use with 2.5mm cutter.

So let’s change the cutter to 1.5mm.

And remember to save new cutter diameter on machine:

System >> Machine parameter >> Cutting setting >> Cutter diameter: 1.5mm

Go back to re-cut again.

Xhorse Dolphin II can normally cut key now…

Cut key success.

Done.

https://www.vvdishop.com/service/xhorse-dolphin-xp005l-toy40-error-code-33-solution.html